Putting Glass Walls on Pennsylvania Slaughterhouses So We Can
See Behind Closed Doors
Hain Pure Protein Corporation
Address: 220 N.Center St, Fredricksburg, PA 17026
Establishment No.: p533
USDA Inspection Report: 10 Aug 2011
Citation: At approximately1204 hours, while performing a 04C04 ISP Code procedure for Finished Product Standards (Processing/Trim Nonconformance) on the Evisceration Line, The test exceeds the subgroup absolute limit of 30. My test results subgroup total was 33, the Processing Nonconformance's were two -extraneous material <, one-oil gland-remnant, seven-oil gland-whole, one-crop-whole, seven-feathers-small, two-feathers-large, and one-long shank-both condyles covered. I immediately notify (Quality Assurance) of my findings. (Evisceration Lead) was also shown the Processing nonconformance. Quality Assurance performed a retested for Finished Product Standard on the evisceration line at 1224 hours for processing nonconformances. The validity test performed by Quality Assurance exceeded the Tolerance number of 25 with a total of [redacted]. I notify Production Manager and (SCSI of the failure mode. SCSIand Quality Assurance immediately conducted a retest at the post chill location using prechill criteria for the processing nonconformance at 1234 hours, and pass. At the prechill station, Quality Assurance retest exceeded the tolerance number of 25 with a total of [redacted] at approximately 1238 hours. Quality Assurance performed two consecutive retests for Finished Product Standard processing nonconformance's on the evisceration line at approximately 1247 hours and 1257 hours with both retests passed. Quality Assurance tagged 2 carcasses with tags to mark the end of the failure mode at approximately 1258 hours. At the Post Chill Station, Quality Assurance performed retests for processing nonconformance at approximately 1240 hours, 1247 hours 1326 hours, and passed. At approximately 1345 hour, the tags came out of the chiller marking the end of the failure mode. This is a failure to comply with 9 CFR 381.76(b). This document serves as a written notification that your failure to comply with regulatory requirement could result in additional enforcement action described in 9 CFR part 500.
381.76(b) Presentation: Each inspector shall be flanked by an establishment employee assigned to be the inspector’s helper. The one inspector on the SIS–1 line shall be presented every bird. Each inspector on the SIS–2 line shall be presented every other bird on the line. An establishment employee shall present each bird to the inspector properly eviscerated with the back side toward the inspector and the viscera uniformly trailing or leading. Each inspector shall inspect the inside, viscera, and outside of all birds presented.